This is a budget SUPER Mini CMOS 700Line Camera. The Quality is not perfect but it is extremely light weight for mini FPV Quad.
This is the CMOS Solution (700TVL) for FPV Camera which supports wide voltage input between 5 - 12V.
The tiny cables to to camera
Do I Need PAL or NTSC Standard?
- Red: Voltage (Positive +)
- Black: Voltage (Positive -)
- Yellow: Video Input
- White: Audio Input
Modern TVs (the new ones) usually support both standards but some old TV would still either support PAL or NTSC. Some CCTV Appliances have the option to let you choose either PAL or NTSC standard to display and record. But it is always good to choose the standard that your country has implemented. Please visit below pages for more information and to find out the standard of your country.
** IMPORTANT: We test each camera using CCTV System in order to verify the standard after we receive the stock from the factory. However, please forgive us if you receive a different standard than you have selected since something we might mess up the standard but it is rare but it does not really matter if you are using the camera on FPV because you will have a choice to set the standard on FPV equipment.
- Resolution: CMOS 700TV Lines
- Power Source:
- DC5 - 12V (connect it directly to the power source, eg. 5V/12V UBEC for FPV Equipment)
- Becareful and make sure it is between 5-12V, even 13V might damage the camera.
- Do not follow the common paper manual (if attached to the camera), the input voltage could be wrong. At your own risk if try.
- Current: 120mA
- Len: 2.8mm
- Audio: Yes
- Dimension (L*W*H): --
- Weight: Approx --g
- 1 x Super Mini Digital CCTV/FPV Camera (2.8mm Len / 700TVL / 5-12V Wide Voltage Input)
** You might see "Black & White Screen" or "Blinking Screen" if the PAL and NTSC are mixed up eg. You connect a PAL camera to NTSC CCTV Appliance.
** Warning: Please use a stable 5V UBEC (RCX07-313 RCX UBEC 3A) instead of connecting the camera directly to the power source (2-3S Lipo), it could damage the camera and no refund / replacement will be offered, so you better test the voltage and make sure it is 5V before using it. Each camera has been tested before shipping.
** Warning: Each camera has been tested by using CCTV system to make sure it is working properly because we need to manually adjust the Len to a "clear" level before locking it up by glue/screw. The camera will burn only if you connect the + / - cables wrongly to the camera or connect an over voltage power source. Please use the default cable shipped with the camera only because not all cameras have the same pin layout on the PCB. Due to this reason, exchange/refund will be offered only after the camera is returned back to us for inspection. Thank you for your kind attention.
Below Videos Made by 700TV Line Camera